UltiMate Long-Life Fasteners

• New Low Profile, self-cleaning head design
• Lifetime warranty against red rust on the UltiMate head
• Cast zinc head (not capped) prevents head failure during installation; provides excellent surface paint adhesion
• Special undercut entraps sealing washer, even when driven at extreme angles
• EPDM sealing washer assures waterproof seal, even under harsh conditions
• EPDM sealing washer is non-conductive minimizing "Halo" corrosion effect.
• Indented hex head design insures a snug socket fit on the bearing surface, allowing fastener to be driven perpendicular to the panel for fast, easy installation.
• Carbon steel shank
• .0003 minimum mechanical zinc plated shank.

Back to top of page

Recommended Driving Speeds:

Drilling Fasteners:

#6 - #10 use an electric screw gun with depth sensing nose piece at 2,500 RPM max.

#12 - #18 use an electric screw gun with depth sensing nose piece at 2,000 RPM max.

Self-Tapping Fasteners:

Carbon & 410 Stainless use an electric screw gun with depth sensing nose piece at 2,000 RPM max.

304 Stainless use an electric screw gun with depth sensing nose piece at 800 RPM max.

Back to top of page

All test results and recommendations are based on laboratory tests. Specific job site conditions should be taken into consideration when specifying the proper fastener. Because applications vary, we assume no liability for use of this information.