OXYSEAL II LONGLIFE COATING

Oxyseal is an effective, economical way to further protect Atlas fasteners from corrosion.  This durable coating can be applied to the head - and threads, if desired - of all Atlas fasteners.

The basic plating is mechanically applied zinc with a minimum thickness of 0.3 mil.  The post-plating film is carefully compounded to be nonconductive and acid resistant.  It is also resistant to chipping, abrasion, and scuffing from socket impact.

SPECIFICATIONS

Type:              Modified Acrylic - Epoxy Water Base (Flouropolymer Aluminum Teflon Base)

Application:    Dip - Spin; stirred well before use

Use:                 Roof & metal building screws
                        Plated fasteners
                        Pneumatically driven fasteners
                        Deck screws
                        Fasteners requiring a nonconductive finish

2-Coat Corrosion Resistance:
    Applied over .0003 inch minimum mechanical zinc plate
    SFW 2.0 S DIN 50018 Kesternich - 21 cycles
    Water Immersion - no effect
    ASTM B117 Salt Spray - 1,000 hours
    Humidity - 1,000 hours
    note: test results depend on pretreatment, dry film thickness, and cure.

All test results and recommendations are based on laboratory tests.  Specific job site conditions should be taken into consideration when specifying the proper fastener.   Because applications vary, we assume no liability for use of this information. 

---

Send an e-mail with questions or comments about this web site.  Sales Contacts   Tech Support Questions
Copyright © 2008 Atlas Bolt & Screw Company
Last modified: October 16, 2008